Me postulé a través de una recomendación de un empleado. El proceso tomó más de 1 semana. Acudí a una entrevista en Texas Instruments (Bengaluru) en sept 2009
Entrevista
The company takes enough time to find best talent in the market.
I had technical written test that was very practical and was tricky. I won't it was the toughest but definitely was tough to answer as they also had negative score.
Two rounds of face to face technical interviews. Depends on who is conducting the interview but mostly importantly one has to be really strong in basics and practical implementations.
One round with the Sales Director, was a formal discussion but they check your attitude, confidence level and commitment to the company.
HR round is again a casual talk. This is a recheck on your commitment.
The entire process may happen in as low as a week or as high as few months, especially while recruiting freshers.
Preguntas de entrevista [1]
Pregunta 1
It wasn't unexpected but it could tough for most. A question on circuit that is purposely created wrong involving basic electronic components.
Me postulé en línea. Acudí a una entrevista en Texas Instruments
Entrevista
I applied online process summarized below
1. Written test (objective type questions technical and aptitude both)
after 20 days they called me for interview at Delhi office
2 round of technical interview there
then after 2days they confirmed that i have cleared technical rounds.
3.Then there was HR round which was telephonic.
4.After HR confirmation Mangers also talked over phone.After 2day They give me confirmation call.
Technical is the most difficult part question asked from only basics RC circuit,diodes,BJT,Opamp only.
HR question was regular.
Overall experience is great.
Me postulé a través de una facultad o universidad. El proceso tomó 2 días. Acudí a una entrevista en Texas Instruments (Gurgaon, Haryana) en ago 2014
Entrevista
Got selecting through a written test on campus. Was called to their office in Gurgaon the next day for interviews. There were two round of interviews- the first one involved discussing the approach I followed in solving the questions in their written examination and also solving the ones which I wasn't able to crack, following the hints which my interviewer gave me. This round lasted around 1hr 45mins and they told me I was selected for the next round before the previous one was over. In the next round, a relatively senior guy took my interview and asked my one question (which we covered two semesters later) and led me to the solution. Even though I gave the correct answer, he suggested a simple and better approach.
Both the interviews went really well and I was really sure of having cracked it, but never got any further intimation, nor did anyone else who applied in the same profile. I later found they didn't select anyone from this profile the previous year too.
Really bad that these guys don't even care to tell you if you haven't made it.
Preguntas de entrevista [1]
Pregunta 1
A normal op amp. 20A into the positive power terminal, 14 A out of the output terminal. How much is the current in the negative power terminal?
Me postulé en línea. El proceso tomó 4 semanas. Acudí a una entrevista en Texas Instruments (Dallas, TX) en dic 2013
Entrevista
Applied online through the Texas Instruments website. I was invited to have a virtual interview and present a project. The interview lasted 1.5 hours, and then I was invited to an onsite interview. I had two interview on site, both lasted a 1 hour each. I had to present an analog driven project.
Preguntas de entrevista [1]
Pregunta 1
How can you get the same results from a half bridge rectifier instead of a full bridge rectifier?
